Drillhole traces intersecting faults
DerekHolom
Posts: 2
in Leapfrog
Answers
-
I have not tried this on open mesh but here is how I do this with solids:
Create Geologic model > Assign base lithology to "none" > create a lithology (named Fualt, or something) > Create deposit or erosion surface from the mesh > activate the mesh in surface chronology.
Drillholes > New Evaluation > Choose your geologic model --- this creates a new table that flags the geologic model onto the drilling.
You may also repeat this but create a "fault system" but I don't have a lot of experience working with faulted geologic models.
0 -
Thanks Michael, I'll give that try.0
Categories
- 771 All Categories
- 169 Products & Software
- 12 Seequent
- 224 Leapfrog
- 352 Geosoft
- 19 GeoStudio
- 11 Developers
- 1 Seequent Evo APIs
- 163 GX Developer
- 1 Early Access Programmes
- 2 Oasis montaj Field EAP