Plotting drilling side tracks in 3D

trying to plot a few drilling side tracks in 3D but the resulting plot shows the drill holes un-merged and plots them several metres below each other. The RL is fine, so puzzled why this happens

Comments

  • BeckyBodger
    BeckyBodger Posts: 338 mod
    Hi @FernandoEncarnacao, sorry about the delay in responding! I think this is a case for support. We would probably need to check out your drillhole project and how it is formatted to figure out why it's plotting this way. Please email [email protected]
    Community Manager

This discussion has been closed.